How to Make an Electroculture Antenna

An electroculture antenna takes half an hour to make. All you need is a wooden stake, a length of copper wire and a pair of pliers. The idea goes back to the antennas of Justin Christofleau in the 1920s: no outside power, just metal standing between air and soil. Here you can read how to make one yourself, what to pay attention to, and how to see whether it does something in your garden.
What you need
- Bare copper wire. No lacquer or plastic, about 12 to 16 AWG (1.5 to 2.5 millimeters). Thinner wire is easier to bend; thicker wire holds its shape better. Plan on 10 to 13 feet (three to four meters) per antenna.
- A wooden stake. Untreated wood, such as hazel, bamboo or a straight branch, about five feet (one and a half meters) long. Part of it goes into the ground, the rest stands above.
- Pliers and wire cutters. To bend and cut the wire.
- A compass. The one on your phone is fine.
If you only have enameled copper wire, such as magnet wire from a spool, sand the coating off first. The coating insulates, and then the copper doesn't touch the air and the soil.
How to make it

- Put the stake in the ground. About 4 to 8 inches (10 to 20 centimeters) deep, firm enough to stay up in the wind.
- Start at the bottom, in the ground. Push the start of the wire a little way into the ground next to the stake. That way the copper makes contact with the soil.
- Wind the wire around the stake. Tightly, with equal spacing between the turns. Most gardeners use five to ten turns over the whole length.
- Make a coil on top. Leave a length of wire sticking out above the stake and twist it into a flat or rising coil of a few turns. That coil is the part most gardeners see as the actual antenna.
- Put it in place. Among the plants, with the coil above the crop. Many gardeners point the opening of the coil north.
Rather not bend it yourself? A ready-made coil of solid copper that you put in the ground or in a pot is the copper plant spiral from Meditech Europe. Living in the US? We ship there on request, just send us a message.
Clockwise or counterclockwise
You'll read a lot about the direction of the coil. Gardeners in the Northern Hemisphere usually say the coil should turn clockwise, seen from bottom to top, and the other way around in the Southern Hemisphere. Some build the coil on the proportion of the golden ratio, with turns that get steadily wider. We haven't found research on what the direction changes. If you want to know, make two antennas with different directions and compare the beds.
Where to put it
- In the vegetable garden. In the middle of a bed, with the coil just above the plants. Gardeners usually count on one antenna per few square yards.
- In a greenhouse or a raised bed. Works too. A smaller antenna or a coil fits well in a bed or a large pot.
- Indoors. In a houseplant you'll more often see a small coil than an antenna on a stake. The idea is the same: copper between air and earth.
Copper changes color outdoors, first brown and later green. That is patina and belongs to it. The wire doesn't need replacing because of it. Why gardeners use copper in particular, you can read under copper.
See for yourself whether it works
The fairest way to see what an antenna does is to compare. Choose two beds with the same soil and the same sun, put an antenna in one bed and leave the other without, sow or plant the same crops on the same day, and weigh the harvest at the end of the season. That's how we did it with pyramids too, in our garden trial. Where the idea comes from, from Bertholon to Lakhovsky, you can read at electroculture.
Frequently asked questions
What copper wire do you use for an electroculture antenna?
Bare copper wire of about 12 to 16 AWG (1.5 to 2.5 millimeters), with no lacquer or plastic. Enameled wire works too, if you sand the coating off first.
How tall should an electroculture antenna be?
Usually 3 to 5 feet (1 to 1.5 meters) above the ground, so the coil rises above the plants. In a raised bed or a pot a smaller antenna is enough.
Does the coil have to turn clockwise?
Gardeners in the Northern Hemisphere usually say yes, seen from bottom to top. We haven't found research on the difference. Compare it yourself with two beds.
How many antennas do you need?
Gardeners usually count on one antenna per few square yards. Start with one per bed, so you can compare well with a bed without.
Does an electroculture antenna need power?
No. An antenna works without a battery or a connection. The idea is that the copper uses the natural electricity between air and soil, as Christofleau described it in the 1920s.
Can I use a ready-made coil instead?
Yes. A coil of solid copper goes straight into the ground or a pot. There is a copper plant spiral in two sizes.

Written by Marijn Makkes van der Deijl, who has been working with copper and pyramids since 2019.
Sources
- Christofleau, J. (1923). Augmentation des récoltes et sauvetage des arbres malades par l'électroculture. La Queue-les-Yvelines.
- Lakhovsky, G. (1929). Le Secret de la vie: ondes cosmiques et radiation vitale. Paris: Gauthier-Villars. English edition: The Secret of Life (1939). London: Heinemann.
Last updated: November 2026